
Wall Mounted Instructions
Before mounting please ensure the wall is suitable for this type of appliance.
1. Find the correct position on the wall following the safety instructions. There must be a minimum
clearance of 10cm between the floor and the base of the heater once in position.
2. Using an electrical drill, drill 2 holes (a,b) into the wall. The distance between holes a and b should
be 14.9cm. The depth of the hole should be about 4cm
3. Fix the screws and bracket onto the wall, please pay attention to the position of the bracket and if
any hazards are within range.
4. Line up the holes of the bracket to the back of the heater and let the clip hold the heater. Screw the
heater to the bracket through the alingned holes.
Operating the Heater
1. Fix the heater securely to the wall according to the mounting instructions above.
2. Plug the unit into a power socket. Do not to use the same electrical socket as another high wattage
electrical appliance in order to avoid overloading the circuit.
3. Turn the thermostat knob fully in a clockwise direction to gain the maximum setting.
4. When the desired room temperature has been reached, the thermostat knob should be turned slowly
anti-clockwise until the thermostat is heard to click off, and the light is seen to go out.
5. After this the heater will keep the air temperature in the room at the set temperature by switching on
and off automatically.
6. In its minimum (fully anti-clockwise) position, the thermostat provides frost protection. In this position
(depending on the size of the room) the heater will maintain the temperature above freezing.
Cleaning
Always unplug the heater from the wall and allow it to cool. Clean the outside by wiping with a damp cloth
(not wet). Do not use detergents or abrasives materials. Do not allow for any water to enter the heater. You
can use a vacuum cleaner to remove dust from the inlet and outlet grille.
Storage
When the heater is not used for long periods of time, it should be protected from dust and stored in a clean
dry place. The original packaging box can be saved and used to store the heater away.
Comentarios a estos manuales